![]() ![]() Let the system do it to avoid issues with access rights. The system will copy the config to /primary. Just insert the card and reboot (or wait for midnight). ![]() Format the card with manager, and recreate it. Eject the card and copy the /dynamic folder. the v2 unit or a firmware problem?Īnd to get it fixed with recreating the card, would mean the safest way is: This sets the version of software loaded when recreating the System SD card. For system installation, you should use the version of IP Office Manager that matches the IP Office release required on the system. Since the BIN is already there and static it can boot from it, but because of problems with the SD card handling it may have problems to properly write the CFG and hence cannot use it for next boot.īut what is the cause? The card, the writer i.e. It is important to download and install the correct version of the IP Office administration suite including IP Office Manager. This means, if a BIN is found in /primary but the CFG is not present or not valid, it uses the CFG from NVRAM and copies it over to /primary and raise an alarm. If NVRAM had to be used, it tries to copy it to /primary and raise an alarm. The order is SD card location of loaded BIN, then NVRAM. ![]() It does not look in /backup or optional card when booted from system SD card. If not, NVRAM is used or a default config. It does this in /primary, NVRAM, /backup, opt/primary, opt/backup, BOOTP.ĭepending on where it founds a IP500v2.bin it will take a config file from the same location if possible. In the end it may be a read-only problem, but the way IPO is booting is more complex.įirst it looks for a IP500v2.bin file. I had to read the docs several time to understand. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |